To Apply: 1. Works best for smooth surfaces, important: Apply to a clean and dry surface. To clean, use a cloth dampened with water or isopropyl rubbing alcohol. Do not use household cleaners. Separate strips. 2. Remove blue liner. Press adhesive to clip. 3. Remove black wall side liner. 4. Press firmly along the entire clip for 30 seconds. Wait 1 hour before use. To Remove: 1. Never pull strip towards you. 2. Hold clip gently to prevent clip from snapping fingers. Do not press clip against wall. 3. Stretch straight down along wall at least 6 inches (15 cm) until strip releases from wall. Important: Failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: Apply to surfaces above 15 degrees F (-9 degrees C). May lose adhesion below -20 degrees F (-29 degrees C) or above 125 degrees F (51 degrees C). Intended for outdoor use only. Not recommended for use on rough surfaces, such as cement board, brick or rough-sawn wood. Not intended for picture hanging. Use one clip for every 2 feet of lights.

3M Command Outdoor Damage-Free Foam Refill Strips

Buy 3M Command Outdoor Damage-Free Foam Refill Strips online with quick same day delivery to your door. Shop with Shipt